Torque Converter Housing with Fluid Pump Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Torque Converter Housing & Fluid Pump Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	NEW Fluid Pump Seal
2	Torque Converter (with Fluid Pump) Housing Assembly NOTE: Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
3	Bolts M10 x 50 (Quantity: 9) Tighten: Tighten to 72 N.m (53 lb ft) in the sequence shown.
4	NEW Turbine Shaft (O-Ring) Seal