Torque Converter Housing with Fluid Pump Assemble
WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Torque Converter Housing with Fluid Pump Assemble
| Callout | Component Name |
|---|---|
| Tip: If installing a NEW pump rotor and slide into the torque converter housing, ensure to properly select the correct rotor and slide before performing this procedure. Refer to Fluid Pump Selective Measurement and Fluid Pump Selective Specifications . | |
| 1 | Fluid Pump Slide Fluid Seal Ring |
| 2 | Fluid Pump Slide (O-Ring) Seal |
| 3 | Fluid Pump Slide Pivot Pin |
| 4 | Fluid Pump Slide Seal Support Tip: The seal support is circular. The seal is rectangular. |
| 5 | Slide Seal |
| 6 | Fluid Pump Slide |
| 7 | Fluid Pump Slide Outer Spring |
| 8 | Fluid Pump Vane Ring |
| 9 | Fluid Pump Rotor Guide
NOTE:
Align the rotor guide tabs to the notches on the bottom of the rotor. Failure to do so may cause transmission damage.
|
| 10 | Fluid Pump Rotor |
| 11 | Fluid Pump Vanes (Quantity: 13) |
| 12 | Fluid Pump Vane Ring |