LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Assemble

Output Shaft Assemble

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Output Shaft Component View
GM1696424Courtesy of GENERAL MOTORS CORP.
Output Shaft Assemble

Callout Component Name
1 Output Carrier Internal Rear Gear
NOTE: Install the gear chamfer side down. Failure to install the gear chamfer side down may result in transmission damage.
2 Output Gear Internal Gear Spacer
3 Output Carrier Internal Gear Retaining Ring
Tip:  Do not install the output carrier internal front gear and retaining ring yet. These components will be installed during assembly of the output carrier to the output shaft.
scientia non olet · About LEMON Manuals