Output Carrier Assembly Overhaul (6L80)

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Output Carrier Assembly Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Output Carrier Front Sun Gear Thrust Bearing Assembly
2	Center Support Roller Bearing NOTE: Do not reuse the center support roller bearing. Install a NEW center support roller bearing. Reusing an old bearing may result in damage to the output carrier. Tip: The thick side of the bearing shell faces up. Special Tools DT 47857 Bearing Installer. See Special Tools . J 6125-B Slide Hammer. See Special Tools . J 8092 Driver Handle J 23129 Universal Seal Remover. See Special Tools .
3	Output Carrier Front Sun Gear NOTE: Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.
4	Output Carrier Front Sun Gear Rear Thrust Bearing Assembly
5	Output Carrier Rear Sun Gear NOTE: Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.
6	Output Carrier Rear Sun Gear Bearing Assembly Tip: Inspect for damage only. Do not remove. The bearing assembly is not a serviceable component.