Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fluid Pump Cover Assembly, Cover Bolt Tightening Sequence, 1-2-3-4 & 3-5 Reverse Clutch Housing Thrust Washer & Alignment Tool

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolts M6 x 40 (Quantity: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt Tip: Center the J 46664 around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. See Special Tools . Tighten the fluid pump cover bolts in the sequence shown. Tighten: Tighten to 11 N.m (97 lb in) Special Tool: J 46664 Pump Cover Alignment Tool. See Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer