LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Input and Output Speed Sensor Assembly Removal

Input and Output Speed Sensor Assembly Removal

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input and Output Speed Sensor Assembly Component View
GM1627571Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Removal

Callout Component Name
1 Bolt M6 x 20 (Quantity: 2)
2 Speed Sensor Electrical Connector
Tip:  Release the connector lock before disconnecting.
3 A/Trans Input and Output Speed Sensor Assembly
4 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Quantity: 2)
Tip:  Inspect the clips and replace if damaged.
scientia non olet · About LEMON Manuals