LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Valve Body, Control Solenoid Torque Sequence

Valve Body, Control Solenoid Torque Sequence

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Solenoid Torque Sequence & Bolts
GM1627747Courtesy of GENERAL MOTORS CORP.
Valve Body, Control Solenoid Torque Sequence

Callout Component Name
NOTE: Bolt torque sequencing is critical to the proper function of the control solenoid valve assembly. Failure to follow the required sequencing may result in transmission malfunction.
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Tip: 
  1. Hand tighten the last 6 bolts before final torque sequence.
  2. The 2 "heat sink" bolts must be tightened last.
1 Bolts M5 x 45 (Quantity: 5)
2 Bolt M5 x 55

Tighten:  Tighten all 18 bolts in the sequence shown to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals