LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Upper to Lower Control Valve Body Assemblies Assemble

Upper to Lower Control Valve Body Assemblies Assemble

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Valve Body Assembly Component View
GM1627630Courtesy of GENERAL MOTORS CORP.
Upper to Lower Control Valve Body Assemblies Assemble

Callout Component Name
NOTE: Refer to Fastener Notice .
Refer to Fastener Tightening Specifications .
1 Control Valve Body Ball Check Valve (Quantity: 7)
Tip:  Refer to Ball Check Valve Locations .
2 Control Valve Body Spacer (w/Gasket) Plate Assembly
NOTE: Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
3 Control Valve Lower Body Assembly
Tip:  Turn the valve body assembly over after installing to upper body.
4 Bolt M5 x 36 (Quantity: 12)

Tighten:  Tighten the bolts in the sequence shown to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals