Manual Shift Shaft Position Switch Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Manual Shift Shaft Position Switch & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Manual Shift Shaft Position Switch Assembly
2	Manual Valve Link Tip: Align the switch activator slide with the manual valve link.
3	Bolt M5 x 55 Tip: Hand tighten only.
4	A/Trans Manual Shift Shaft Position Switch Harness Clip Tip: The wiring harness clip on the manual shift shaft position switch does not need to be replaced if damaged or missing. The clip functions only as a manufacturing assembly aid to keep the harness clear during an automated bolt installation process. If the clip is damaged, simply remove and discard.
5	A/Trans Manual Shift Shaft Position Switch Electrical Connector Tip: Connect and lock the manual shift shaft position switch electrical connector to the control solenoid valve assembly.