LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Input and Output Speed Sensor Assembly Installation

Input and Output Speed Sensor Assembly Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Input & Output Speed Sensor Assembly & Components
GM1627754Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Installation

Callout Component Name
NOTE: Refer to Fastener Notice .
Refer to Fastener Tightening Specifications .
1 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Quantity: 2)
Tip:  Inspect the 2 wiring harness clips for damage. Replace if damaged.
2 A/Trans Input and Output Speed Sensor Assembly
3 Bolt M6 x 20 (Quantity: 2)

Tighten:  Tighten bolts to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals