Automatic Transmission Electrical Connector Passage Sleeve Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Cadillac Escalade EXT, 2007 Cadillac Escalade ESV, and 2007 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Automatic Transmission Electrical Connector Passage Sleeve & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	NEW Lip Seal
2	NEW O-Ring Seals (Quantity: 2)
3	Electrical Connector Passage Sleeve Specification: 14-16 mm Special Tools DT 47715 Electrical Connector Passage Sleeve Remover/Installer. See Special Tools . J 42183 Driver Handle. See Special Tools . NOTE: Orientate the alignment tab inside the passage sleeve with the slot in the electrical connector of the control solenoid valve assembly. Push the sleeve straight into the case bore and connector. Do NOT rotate the sleeve at any time. Ensure the sleeve is fully seated into the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14-16 mm. Even though the correct electrical connections may still be maintained, failure to ensure proper installation of the sleeve may result in a fluid leak around the sleeve lip seal and into the sleeve cavity.
4	Electrical Connector Slide Lock Tip: Push down on the electrical connector slide lock to ensure proper installation.