LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Vent Hose >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose & Clip
    GM765125Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the transmission.
  2. Install the vent hose to the clip.
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolt and the clamp.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals