LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (2WD)

Transmission Mount Replacement (2WD)

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transmission Mount, Crossmember Nut & Bolts
GM1703322Courtesy of GENERAL MOTORS CORP.
Transmission Mount Replacement (2WD)

Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a transmission jack.
1 Transmission Mount to Crossmember Nut
NOTE: Refer to Fastener Notice .

Tighten:  40 N.m (30 lb ft)
2 Transmission Mount Bolt (Qty: 2)

Tighten:  50 N.m (30 lb ft)
3 Transmission Mount
Tip:  Raise the transmission with the transmission jack just enough to remove the transmission mount.
scientia non olet · About LEMON Manuals