LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grill assembly. Refer to Fascia Grille Replacement (Suburban) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Tahoe Z71) .
    2. Fig 1: View Of Transmission Fluid Cooler Hoses At Auxiliary Oil Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  2. Remove the transmission fluid cooler hose from the auxiliary oil cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  3. Remove the transmission fluid cooler hose from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the engine protection shield. Refer to Engine Shield Replacement .
    6. Fig 2: View Of Transmission Oil Cooler Lines
    GM396804Courtesy of GENERAL MOTORS CORP.
  6. Remove the cooling lines from the transmission. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  7. Remove the oil cooling lines from the vehicle.
scientia non olet · About LEMON Manuals