LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Output Shaft Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the output speed sensor seal with automatic transmission fluid.
  2. Install the output speed sensor (2).
    3. NOTE: Refer to Fastener Notice .
  3. Install the output speed sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

    4. Fig 2: View Of Output Speed Sensor & Electrical Connector
    GM1709733Courtesy of GENERAL MOTORS CORP.
  4. Connect the output speed sensor (1) electrical connector.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals