LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Accumulator Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accumulator Housing Assembly
    GM477683Courtesy of GENERAL MOTORS CORP.
  1. Remove the valve body. Refer to Valve Body and Pressure Switch Replacement .
  2. Remove the 3rd and 4th clutch accumulator housing bolts (1).
  3. Remove the 3rd and 4th clutch accumulator housing (8).
  4. Remove the accumulator housing gasket (6). The accumulator housing gasket may be stuck to the spacer plate (5).
  5. Remove the 3rd clutch accumulator piston spring (7).
  6. Remove the 4th clutch accumulator piston spring (2).
  7. Remove the valve body spacer plate (5).
  8. Remove the valve body to spacer plate gasket (4) from the spacer plate (5).
scientia non olet · About LEMON Manuals