LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Transmission Oil Pump Body Assemble >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

J 38693  Oil Pump Seal Installer. See Special Tools .

    Fig 1: Identifying J 38693
    GM31210Courtesy of GENERAL MOTORS CORP.
  1. Using the J 38693  , install the torque converter oil seal assembly (201). See Special Tools .
    2. Fig 2: View Of Oil Pump Drive Gear & Driven Gear
    GM181748Courtesy of GENERAL MOTORS CORP.
  2. Lubricate the oil pump drive gear (205) and driven gear (204) with DEXRON®VI automatic transmission fluid.
    3. IMPORTANT: The identification dots on the oil pump drive gear (205) must be facing up in order to ensure correct orientation of the drive flats.
  3. Install the oil pump driven gear (204) and drive gear (205) with the identification dots facing up.
scientia non olet · About LEMON Manuals