LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Overdrive Carrier Assembly Assemble >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

J 36850  Transjel® Lubricant

    Fig 1: Locating Overrun Clutch Housing Thrust Bearing Assembly
    GM31129Courtesy of GENERAL MOTORS CORP.
  1. Install the overrun clutch housing thrust bearing assembly (513) into the overdrive carrier assembly (514). Retain with J 36850  or equivalent.
    2. Fig 2: View Of Overdrive Carrier Pinion Gear Components
    GM31137Courtesy of GENERAL MOTORS CORP.
  2. Install one overdrive carrier pinion gear (518) and its roller bearings (517) and thrust washers (515, 516), into the overdrive carrier assembly (514) at the location marked at disassembly.
  3. Install the overdrive carrier pinion gear pin (519).
  4. Repeat steps 2 and 3 until all 4 pinion gear assemblies are installed in their original locations.
    5. Fig 3: View Of Overdrive Carrier Assembly, Pinion Gear Pin Retainer, & Pin Retaining Ring
    GM31125Courtesy of GENERAL MOTORS CORP.
  5. Install the overdrive carrier pinion gear pin retainer (520) on the overdrive carrier assembly (514). Align the pinion gear pins with the retainer slots.
  6. Install the overdrive carrier pinion gear pin retainer retaining ring (521) on the overdrive carrier assembly (514).
scientia non olet · About LEMON Manuals