LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Overdrive Carrier Assemble

Overdrive Carrier Assemble

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Overdrive Clutch Roller Assembly
    GM774707Courtesy of GENERAL MOTORS CORP.
  1. Install the overdrive clutch roller assembly (512) on the overrun clutch housing assembly (504).
    2. IMPORTANT: Rotate the overdrive carrier assembly (514) during installation in order to line up the overdrive clutch plates with the overdrive carrier assembly splines.
  2. Install the overdrive carrier assembly (514) on the overrun clutch housing assembly (504).
    3. Fig 2: View Of Overdrive Carrier Retainer Ring & Turbine Shaft
    GM31185Courtesy of GENERAL MOTORS CORP.
    NOTE: Align the components carefully to avoid damaging the turbine shaft oil seal rings.
  3. Install the turbine shaft (502) through the overrun clutch housing assembly (504) and the overdrive carrier assembly (514).
  4. Install the overdrive carrier retainer ring (522).
scientia non olet · About LEMON Manuals