LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Intermediate Clutch Assembly Removal

Intermediate Clutch Assembly Removal

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intermediate Clutch Assembly
    GM334765Courtesy of GENERAL MOTORS CORP.
  1. Remove the intermediate clutch backing plate retainer ring (629).
  2. Remove the intermediate clutch backing plate (630) and the intermediate clutch plates (631, 632) (4 each).
  3. Remove the intermediate clutch wave plate (684).
  4. Inspect the intermediate clutch plates (631, 632, 684) for the following conditions:
    • Wear
    • Pitting
    • Flaking
    • Cracks
  5. Inspect the intermediate clutch backing plate (630) for the following conditions:
    • Burrs
    • Dirt
scientia non olet · About LEMON Manuals