LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Intermediate Clutch Assembly Installation

Intermediate Clutch Assembly Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intermediate Clutch Plates
    GM334809Courtesy of GENERAL MOTORS CORP.
  1. Dip all of the intermediate clutch plates in DEXRON®VI transmission fluid.
  2. Install the intermediate clutch wave plate (684) with the tangs facing down.
    3. IMPORTANT: Alternate the clutch plates, starting with the steel clutch plate (4 steel and 4 composite).
  3. Install the intermediate clutch plates (631, 632).
  4. Install the intermediate clutch backing plate (630).
    5. Fig 2: Aligning Intermediate Clutch Backing Plate Retainer Ring At 9:00 Position
    GM334811Courtesy of GENERAL MOTORS CORP.
  5. Install the intermediate clutch backing plate retainer ring (629). The opening of the retainer ring (629) should be at the 9 o'clock position.
scientia non olet · About LEMON Manuals