LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Forward Clutch Assembly Removal >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

J 38358-A  Forward Clutch Assembly Remover/Installer. See Special Tools .

    Fig 1: Removing Overdrive Carrier/Forward Clutch Thrust Bearing Assembly
    GM334758Courtesy of GENERAL MOTORS CORP.
  1. Remove the overdrive carrier/forward clutch thrust bearing assembly (601). The bearing may be stuck to the overrun clutch housing assembly.
  2. Using the J 38358-A  , remove the forward clutch housing assembly (602). See Special Tools .
    3. IMPORTANT: The forward clutch housing thrust washer (612) may be on top of the direct clutch housing or stuck to the bottom of the forward clutch housing assembly (602).
  3. Remove the forward clutch housing thrust washer (612).
scientia non olet · About LEMON Manuals