Direct Clutch Assembly Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL and 2007 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 24396 Intermediate Clutch Pack Alignment Tool. See Special Tools .
J 38733 Direct Clutch Assembly Remover/Installer. See Special Tools .

Fig 1: Blowing Air Through Center Support Bolt Hole

Courtesy of GENERAL MOTORS CORP.

Using the J 24396 , align the intermediate clutch plates. See Special Tools .
Apply compressed air through the center support bolt hole to apply the intermediate clutch. Continue applying compressed air to hold the intermediate clutch plates in place until the direct clutch assembly is installed.
Remove the J 24396 . See Special Tools .

Fig 2: Installing Direct Clutch Housing Assembly Into Transmission Case

Courtesy of GENERAL MOTORS CORP.

Using the J 38733 , install the direct clutch housing assembly (623) into the transmission case. See Special Tools . Rotate the direct clutch housing assembly slightly in each direction to ease installation.
Remove the J 38733 . See Special Tools .