LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Auxiliary Oil Cooler, Bolts & Push Pins
    GM711677Courtesy of GENERAL MOTORS CORP.
  1. Install the auxiliary oil cooler to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts (1) and the push pins (2) that retain the auxiliary oil cooler to the radiator brace.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

  3. Connect the transmission oil cooler lines to the auxiliary cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Replacement .
  4. Install the front grill assembly. Refer to Fascia Grille Replacement (Suburban) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Tahoe Z71) .
scientia non olet · About LEMON Manuals