LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Extension Housing Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Install a new case extension O ring seal (3).
  2. Install the case extension (2).
    NOTE: Refer to Fastener Notice .
  3. Install the case extension bolts (1).

    Tighten:  Tighten the bolts (1) to 45 N.m (33 lb ft).

  4. Install the transmission mount. Refer to Transmission Mount Replacement (2WD)  or Transmission Mount Replacement (4WD) .
  5. Install the propeller shaft. Refer to Rear Propeller Shaft Replacement .
  6. Remove the drain pan and the transmission jack.
  7. Lower the vehicle.
  8. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Checking .
scientia non olet · About LEMON Manuals