LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Transmission Fluid Pan Installation

Transmission Fluid Pan Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Oil Pan & Gasket
    GM1265865Courtesy of GENERAL MOTORS CORP.
  1. Place the transmission oil pan gasket (73) on the case.
  2. Place the transmission oil pan (75) on the case.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install all of the transmission oil pan screws (76).

    Tighten:  Tighten the screws to 16 N.m (11.8 lb ft).

scientia non olet · About LEMON Manuals