Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 25019 Bushing Service Set. See Special Tools .
J 34196-B Transmission Bushing Service Set. See Special Tools .
J 7004-A Universal Remover. See Special Tools .
J 8092 Universal Driver Handle - 3/4 in - 10

Fig 1: Inspection Areas On Reverse Input Clutch Housing & Drum Assembly

Courtesy of GENERAL MOTORS CORP.

Inspect the reverse input clutch housing and drum assembly for the following conditions:
- Damaged or worn bushings
- Surface finish on the hub and outer housing - check band surface for flatness
- Leak at the weld
- Heat distortion
- Rolled or distorted retaining ring groove

Fig 2: Identifying Reverse Input Clutch Front Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-16 with the J 7004-A , remove the reverse input clutch front bushing (603). See Special Tools .

Fig 3: Locating Reverse Input Clutch Rear Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-4 with the J 8092 , remove the reverse input clutch rear bushing (606). See Special Tools .