LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Manual Detent Spring Installation

Manual Detent Spring Installation

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manual Detent Spring Assembly
    GM13263Courtesy of GENERAL MOTORS CORP.
  1. Inspect the manual detent spring assembly (63) for cracks or damage.
  2. Install the manual detent spring assembly (63).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the manual detent spring bolt (64).

    Tighten:  Tighten the bolt to 20-27 N.m (15-20 lb ft).

scientia non olet · About LEMON Manuals