LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Input Internal Gear, Reaction Shaft and Shell Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

J 36850  Transjel Lubricant. See Special Tools .

    Fig 1: View Of Input Internal Gear, Reaction Shaft & Sun Shell
    GM1730038Courtesy of GENERAL MOTORS CORP.
  1. Install the reaction sun shell (670) into the reaction sun gear.
  2. Install the thrust bearing (669) using J 36850  onto the reaction carrier shaft, tangs up, toward the shaft. See Special Tools .
  3. Install the input internal gear (664) and reaction carrier shaft (666) assembly into the sun gear shell. Index the reaction carrier shaft spline into the reaction carrier.
scientia non olet · About LEMON Manuals