LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> 2-4 Band, Input Clutches, Input Gear Set Removal

2-4 Band, Input Clutches, Input Gear Set Removal

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Band Anchor Pin
    GM1552920Courtesy of GENERAL MOTORS CORP.
  1. Remove the band anchor pin (41).
    2. Fig 2: Identifying Reverse Input Clutch Assembly & Input Housing
    GM1552921Courtesy of GENERAL MOTORS CORP.
  2. Remove the input housing and shaft assembly (621), along with the reverse input clutch housing and drum assembly (605).
    3. Fig 3: View Of 2-4 Band Assembly
    GM190436Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2-4 band assembly (602).
scientia non olet · About LEMON Manuals