LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> 1-2 Accumulator Assemble

1-2 Accumulator Assemble

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Accumulator Piston & Oil Seal Ring
    GM1730070Courtesy of GENERAL MOTORS CORP.
  1. Inspect the 1-2 accumulator piston (56) for the following conditions:
    • Porosity
    • Cracks
    • Scoring
    • Nicks and Scratches
  2. Install a 1-2 accumulator piston oil seal ring (55) on the 1-2 accumulator piston (56).
    3. Fig 2: Locating 1-2 Accumulator Housing Inspection Areas
    GM828121Courtesy of GENERAL MOTORS CORP.
  3. Inspect the 1-2 accumulator housing for the following conditions:
    • Porosity
    • Cracks
    • Scoring
    • Nicks and Scratches
    • Debris or blocked passages
    4. Fig 3: View Of 1-2 Accumulator Piston, Inner & Outer Accumulator Springs & Housing
    GM1755949Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Some models may not use an outer 1-2 accumulator spring (54).
  4. Install the 1-2 inner (104) and outer (54) accumulator springs.
  5. Install the 1-2 accumulator piston (56).
scientia non olet · About LEMON Manuals