LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Shift Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shift Control Module
    GM856631Courtesy of GENERAL MOTORS CORP.
  1. If a NEW control module is being installed, program the new module. Refer to Control Module References .
  2. Install the shift control module to the bracket.
    3. Fig 2: View Of Shift Control Module Electrical Connectors
    GM885116Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control module electrical connectors.
  4. Start the engine and test the automatic transfer case system for proper shift operation.
scientia non olet · About LEMON Manuals