LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: J 8092 & J 43484
    GM678236Courtesy of GENERAL MOTORS CORP.
  1. Install the J 43484  (2) to the J 8092  (1).
  2. Install the seal onto the J 43484  .
  3. Using the J 43484  (2) and the J 8092  (1), install the seal.
  4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.
  5. Check the fluid level. Add fluid if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals