LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer case).
    Fig 1: Installing Transfer Case Input Shaft Seal
    GM678288Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The input shaft seal should be even with the surface of the transfer case after installation.
  1. Align the transfer case input shaft seal evenly on the input shaft.
  2. Using the J 42738  , install the transfer case input shaft seal.
  3. Install the transfer case. Refer to Transfer Case Assembly Replacement .
  4. Check the fluid level. Add fluid if necessary.
scientia non olet · About LEMON Manuals