LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When performing the following procedures, use only hand tools to remove and install the drain and fill plugs.
    Fig 1: View Of Transfer Case Fill Plug
    GM660281Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the fill plug.
    4. Fig 2: View Of Transfer Case Drain Plug
    GM660282Courtesy of GENERAL MOTORS CORP.
  4. Remove the drain plug.
scientia non olet · About LEMON Manuals