LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Encoder Motor Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Encoder Harness Connector
    GM1361874Courtesy of GENERAL MOTORS CORP.
  1. Assemble the harness to the NEW encoder with the connector legend "TOP" (1) and the encoder part number facing up.
  2. Assemble the output shaft into the encoder being sure to align the encoder tab with the groove on the shaft.
  3. Ensure the encoder is seating properly on the output gear.
  4. Place the output shaft/encoder on the casting.
  5. Place the grommet harness on the casting slot, the flat area on the grommet will be facing up.
    6. Fig 2: Casting & Output Gear Timing Marks
    GM1361879Courtesy of GENERAL MOTORS CORP.
  6. With the output gear/encoder assembly in hand, carefully align the casting and output gear timing marks (1).
    7. Fig 3: Encoder Phasing Post & Phasing Slot
    GM1361877Courtesy of GENERAL MOTORS CORP.
  7. At the same time be sure to align the encoder phasing post (1) with the phasing slot (2) in the casting and insert the shaft into the bushing.
  8. Verify that the output gear and idler gear are engaged properly.
  9. Seat the harness wires on the casting channel.
  10. Place the shim on the output shaft gear.
  11. Press a NEW seal into the cover.
    12. Fig 4: Motor Cover & Casting Screws
    GM1341854Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  12. Install the cover.
  13. Install 2 NEW screws (1) to the casting.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  14. Install 2 NEW longer screws (2) to the motor cover.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  15. Install the encoder motor. Refer to Transfer Case Encoder Motor Replacement .
scientia non olet · About LEMON Manuals