Scan Tool Data List
The SIR Scan Tool Data List contains all the restraint system related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column, "Data List," indicates the location of the parameter within the scan tool menu selections.
Use the SIR Scan Tool Data List as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check - Vehicle . Use the SIR Scan Tool Data List after the following are determined:
- There is no published DTC procedure nor published symptom procedure for the customer concern.
- The DTC or symptom diagnostic procedure indicated by the diagnostic system check does not resolve the customer concern.
The Typical Data Values are obtained from a properly operating vehicle under the conditions specified in the first row of the Scan Tool Data List table. Comparison of the parameter values from the suspect vehicle with the Typical Data Values may reveal the source of the customer concern.
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Driver Seat Belt Buckled/Active Switch Enabled | |||
| 8-Digit GM Part Number | Module Information 2 | 8-digit number | XXXXXXXX |
| Active Switch | Inputs | Enabled/Disabled | Enabled |
| Calibration ID | Module Information 1 | 4-digit number | Varies |
| Component Serial Number | Module Information 2 | 4-digit number | XXXX |
| Driver Side Belt Status | Inputs | Buckled/Unbuckled | Buckled |
| Electronic Front End Sensor 1 ID | Module Information 1 | 2-digit number | Varies |
| Electronic Front End Sensor 2 ID | Module Information 1 | 2-digit number | Varies |
| Ignition Voltage | Data | Volts | 12 volts |
| Julian Date of Build | Module Information 1 | 3-digit number | Varies |
| ROM ID | Module Information 1 | 4-digit number | Varies |
| Year Module Built | Module Information 1 | 4-digit number | Varies |