LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (HVAC System - Automatic) >> Repair Instructions >> Inside Air Temperature Sensor Assembly Replacement - Auxiliary >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the third pillar molding. Refer to Garnish Molding Replacement - Center Pillar Upper .
  2. Remove the left rear coat hook, if equipped. Refer to Coat Hook Replacement .
  3. Remove the rear headliner retainers from the front headliner.
  4. Carefully lower the headliner from the roof Velcro retainers.
    5. Fig 1: View Of Inside Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the inside air temperature sensor.
    6. Fig 2: View Of Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
  6. Partially remove the auxiliary inside air temperature sensor from the headliner.
  7. Remove the sensor grille from the auxiliary inside air temperature sensor.
  8. Remove the auxiliary inside air temperature sensor from the headliner.
scientia non olet · About LEMON Manuals