LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Valley Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: All gasket surfaces should be free of oil or other foreign material during assembly.
    Fig 1: View Of Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent, to the threads of the oil pressure sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install a NEW washer (707) and the oil pressure sensor (706).

    Tighten:  Tighten the sensor to 35 N.m (26 lb ft).

    3. Fig 2: View Of Engine Valley Cover & Gasket
    GM1403316Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the O-ring seals with clean engine oil.
  4. Install the O-ring seals (537) to the cover.
  5. Set the engine valley cover (555) onto the engine.
  6. Install the engine valley cover bolts (506).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  7. Install the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9/LMG/LY5/L76/L92)  or Intake Manifold Replacement (RPOs LY2/LY6) .
scientia non olet · About LEMON Manuals