LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (2500 w/RPO LY6) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701903Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine block.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Working through the wheelhouse opening, install the engine mount to engine block bolts (1).

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (2500 w/RPO LY6) .
scientia non olet · About LEMON Manuals