LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (1500 w/RPO LY2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  5. Remove the battery cable attachment on the frame.
  6. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
  7. Remove exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side .
  8. Remove the starter. Refer to Starter Replacement .
    9. Fig 1: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  9. Remove the engine mount to frame bolts (1)
  10. Position an adjustable jack and a block of wood under the engine oil pan and raise the engine slightly.
  11. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
    Fig 2: View Of Engine Mount To Engine Bolts
    GM1701799Courtesy of GENERAL MOTORS COMPANY
    12. Fig 3: View Of Engine Mount
    GM1701802Courtesy of GENERAL MOTORS COMPANY
  12. Remove the engine mount through the rear of the wheelhouse opening.
scientia non olet · About LEMON Manuals