LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Left Side (2500 w/RPO LY6) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.
  1. Remove the left engine mount bracket. Refer to Engine Mount Bracket Replacement - Left Side (2500 w/RPO LY6) .
    Fig 1: View Of Engine Mount Bracket Bolts
    GM1701899Courtesy of GENERAL MOTORS CORP.
  2. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
  3. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
  4. Remove the engine mount through the rear of the wheel well opening.
    Fig 2: View Of Engine Mount
    GM1701901Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals