LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Left Side (2500 w/RPO LY6) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the engine mount to the engine block.
    2. Fig 1: View Of Engine Mount
    GM1701901Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    Fig 2: View Of Engine Mount To Engine Bolts
    GM1701899Courtesy of GENERAL MOTORS CORP.
  2. Working through the wheelhouse opening, install the engine mount to engine bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the left engine mount bracket. Refer to Engine Mount Bracket Replacement - Left Side (2500 w/RPO LY6) .
scientia non olet · About LEMON Manuals