LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
  1. Remove the air conditioning (A/C) drive belt. Refer to Drive Belt Replacement - Air Conditioning .
  2. Remove the cooling fan and shroud. Refer to Cooling Fan and Shroud Replacement .
  3. Remove the starter motor. Refer to Starter Motor Replacement .
    4. NOTE: Refer to Fastener Notice .
    IMPORTANT: Ensure that the teeth of the J 42386-A  mesh with the teeth of the engine flywheel. See Special Tools .
  4. Install the J 42386-A  (1) and bolts. See Special Tools . Use one M10-1.5 x 120 mm and one M10-1.5 x 45 mm bolt for proper tool operation.

    Tighten:  Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).

    5. Fig 2: View Of Used Crankshaft Balancer Bolt
    GM1658287Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft balancer bolt (139). Do not discard the crankshaft balancer bolt at this time. The old balancer bolt will be used during the balancer installation procedure.
    6. Fig 3: View Of Crankshaft Balancer With J 41816 & J 41816-2 Removal Tools
    GM1402060Courtesy of GENERAL MOTORS CORP.
  6. Install the J 41816  (1) and J 41816-2  (2) to the crankshaft balancer. See Special Tools .
    7. Fig 4: View Of Crankshaft Balancer
    GM1658138Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The crankshaft balancer is balanced as an individual component. It is not necessary to mark the balancer prior to removal.
  7. Use the J 41816  and the J 41816-2  to remove the crankshaft balancer (138). See Special Tools .
  8. Remove the J 41816  and the J 41816-2  from the crankshaft balancer. See Special Tools .
scientia non olet · About LEMON Manuals