LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Position Actuator Magnet Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  1. Remove the water pump. Refer to Water Pump Replacement (RPOs LY2/LC9/LY5/LMG) or Water Pump Replacement (RPOs LY6/L76/L92) .
  2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
  3. Remove the CMP actuator magnet bolts (751) and magnet (752).
  4. Remove and discard the CMP actuator magnet gasket (753).
scientia non olet · About LEMON Manuals