LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Clunk When Accelerating from Coast

Clunk When Accelerating from Coast

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Clunk When Accelerating from Coast

Step Action Value(s) Yes No
DEFINITION: A clunking noise present when accelerating from coast to drive under load.
1 Check for a loose wheel drive shaft to hub assembly nut.
Is the wheel drive shaft nut loose?
- Go to Step 2  Go to Step 3 
2 Tighten the wheel drive shaft to hub assembly nut to specification.
Is the repair complete?
240 N.m
(177 lb ft)
System OK -
3 Check for a damaged inner CV joint.
Is the inner CV joint damaged?
- Go to Step 4  System OK
4 Replace the inner CV joint. Refer to Wheel Drive Shaft Inner Joint and Seal Replacement .
Is the repair complete?
- System OK -