LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Clunk Noise When Accelerating During Turns

Clunk Noise When Accelerating During Turns

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Clunk Noise When Accelerating During Turns

Step Action Yes No
1 Check for worn or damaged outer CV joints and/or seals.
Are the outer CV joints/seals worn?		 Go to Step 2  System OK
2 Replace the outer CV joints/seals. Refer to Wheel Drive Shaft Outer Joint and Seal Replacement .
Is the repair complete?		 System OK -
scientia non olet · About LEMON Manuals