LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pitman Shaft & Cover Assembly
    GM412387Courtesy of GENERAL MOTORS CORP.
  1. Install the new pitman shaft cover O-ring (4).
  2. Install the pitman shaft and cover assembly (3) onto the steering gear housing assembly.
  3. Install the lash adjuster nut (2) onto the pitman shaft and cover assembly (3)
    4. NOTE: Refer to Fastener Notice .
  4. Install the pitman shaft cover bolts (1) onto the pitman shaft and cover assembly (3).

    Tighten:  Tighten the pitman shaft cover bolts to 62 N.m (46 lb ft).

    5. Fig 2: View Of Steering Gear Housing, Lock Washer & Nut (670 Gear)
    GM740401Courtesy of GENERAL MOTORS CORP.
  5. Install the lock washer (2).
  6. Install the nut (3).
  7. If necessary adjust the pitman shaft. Refer to Pitman Shaft Over-Center Preload Adjustment - Off Vehicle .
scientia non olet · About LEMON Manuals