LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assemblies/O-Ring Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cylinder Line Retaining Plate & Bolt
    GM1751420Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Protect the boots from sharp tools and from the sharp edges of surrounding components.
  1. Remove the bolt (1) from the cylinder line retaining plate (2) at the valve end.
  2. Remove the cylinder line retaining plate (2).
    3. Fig 2: View Of Rack & Pinion Gear Assembly, Cylinder Line Assemblies, O-Ring Seals & Valve End
    GM1751427Courtesy of GENERAL MOTORS CORP.
  3. Loosen both cylinder line nuts (3) on cylinder end of the gear assembly (1).
  4. Remove both cylinder line assemblies (2) from the rack and pinion gear assembly (1).
  5. Remove and discard the O-rings seals (4) from the valve end (5).
scientia non olet · About LEMON Manuals