Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- To remove the rack and pinion boot. Refer to Rack and Pinion Boot Replacement .
- Place a pipe wrench on the rack (1) next to the inner tie rod housing.
- Place a wrench on the flats of the inner tie rod housing (2).
- Rotate the inner tie rod housing (2) counterclockwise, while holding the rack stationary, until the inner tie rod separates from the rack (1).
NOTE:
Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
NOTE:
The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe wrench in any other location will cause damage to the steering gear.